Products

Ladder Mesh Masonry Reinforcement

Masonry ladder&truss type reinforcement mesh Raw material:low carbon steel wire,stainless steel wire .

The mesh can be electro galvanized or hot dip galvanized after welding,it mainly have two type,ladder type and truss type.

the wire diameter is from2.5mm to 6mm.

Uses:it is widely used for reinforcing wall. We can produce according to the customer's demand.

Brick Wall Reinforced Mesh, Used in Building Surface, Wall, Ground and Bridge.

Customized specifications and sizes are accepted.




Raw material:

Raw material: low carbon steel and stainless steel wires

Variety:

truss-mesh reinforcement,  ladder-mesh reinforcement

Surface Treatment:

Welded after hot dipped galvanized

Welded after electro galvanized

Welded before electro galvanized

Welded before hot dipped galvanized

Welded by stainless steel wire

Specifications

Wire Diameter: 2.5-6.0 mm

Width: 5cm,10cm,15cm,20cm

Length: 3mm 

Spacing: 40cm

Customized specifications and sizes are accepted

Package:

carton/pallet/plastic wrapped

 

Feature:

welding spots of warp wire and weft wire are on the same surface

reduce cracking , increase lateral flexural strength, increase elasticity


Uses: We specialize in innovative products for the building industry. Products that provide substantial time and cost savings over the tedious, traditional work methods. Mainly used in building surface, wall, ground, bridge, bank and airport.

We produce welded wire sheets for reinforced concrete construction with specifications and sizes as clients' requirements.